When you have always had them on your cars since you were in diapers, you get used to them. I have smaller custom plates which look far neater than the standard state plates. But I know where you are coming from.Remind me to never move to a state that requires license plates on the front...
What series??Not super scenic, but took her for a drive to a local bar that was formerly a shooting location for a popular series.
View attachment 45587
View attachment 45588
Do you have KW coilovers installed? If so, do you like them?Last monday I had a muffler delete done (with new pipes being 2.5" rather than 2") and I had not done my homework too well and did not know that I would require new tips instantly, therefore I've been driving around with an enormous level of inside the cabin noise (especially low rpm-slow acceleration reverberation as well as 3000+rpm in 2nd/3rd/4th gear).
So today I ordered new tips that I will get welded on to the new Y pipes on both sides on wednesday and also some STP sound deadening materials to sound deaden the whole trunk area + below the rear seats. My understanding is that these two things together should kill the reverberation inside.
We tested how big of an effect the poorly shaped bottom area of the trunk has on the reverberation and it was huge, when things are inside the way it creates the extra noise is crazy compared to when the trunk is completely empty.
But until then, a picture of the beautiful handicraft under the car.
In the long run will make it into a custom system with remote EVC-s and probably some crazy sound when the valves are open!View attachment 45579
I have KW lowering springs installed and they are absolutely amazing, exactly the right drop and stiffness. Coilovers would be the next step in terms of adjustability etc but don't need it.Do you have KW coilovers installed? If so, do you like them?
Hey, the Y pipes are on (as on the picture) but they are missing the new tips, but clips as it currently is:Can you do a sound clip when you get the Y-pipes on?
Poke the center of each bubble with a needle. They'll seal right up in a day or two.Put on my tinted taillight overlays.View attachment 45591They look good from this distance, but there are quite a few bubbles.Hope they go away on there own.
Works around here. But that's because no front plate is not a first offense; cops can tack "no front plate" onto a moving violation, though they seldom do.
Yeah the Evora is low. Also being an earlier one it has a huge door sill to climb over as well.Gee, to think that I complain that the Stinger is rather low and hard to climb out of...![]()
Hah I wish I need to order new ones that fit better but these do the job for now of minimizing MBRP exhaust drone.Are those flame thrower tips on your Stinger ?? there a HUGE lol
Yeah the Evora is low. Also being an earlier one it has a huge door sill to climb over as well.
Hah I wish I need to order new ones that fit better but these do the job for now of minimizing MBRP exhaust drone.