Bear
Active Member
Finally bit the bullet and also got the wife to agree to exhaust. We decided to go with Borla because it was cheaper, I’ve had it in the past on Mustangs and it sounded good based on other users videos.
Install was beyond easy and should only take 30min or less. I did need an air compressor to get a couple of nuts off and of course it speeds up the install. I initially tried keep the cross bar untouched (about midway under the car), but needed to move it to unbolt the stock exhaust. Having long extensions (12”-18”) and swivels will help tremendously!
The exhaust has a much deeper growl at RPMs between 1500-2500. It’s certainly much louder inside than stock, but not too loud in my opinion. Once you get to about 3000 RPM, it sounds about same as stock inside.
Couple videos and a special video.
Stock exhaust:
Dropbox - Video May 03, 7 20 42 PM.mov
Borla exhaust:
Dropbox - Video May 03, 8 47 06 PM.mov
Apparently my Borla isn't loud enough...
Dropbox - Video May 03, 9 09 38 PM.mov
Install was beyond easy and should only take 30min or less. I did need an air compressor to get a couple of nuts off and of course it speeds up the install. I initially tried keep the cross bar untouched (about midway under the car), but needed to move it to unbolt the stock exhaust. Having long extensions (12”-18”) and swivels will help tremendously!
The exhaust has a much deeper growl at RPMs between 1500-2500. It’s certainly much louder inside than stock, but not too loud in my opinion. Once you get to about 3000 RPM, it sounds about same as stock inside.
Couple videos and a special video.
Stock exhaust:
Dropbox - Video May 03, 7 20 42 PM.mov
Borla exhaust:
Dropbox - Video May 03, 8 47 06 PM.mov
Apparently my Borla isn't loud enough...
Dropbox - Video May 03, 9 09 38 PM.mov