JB4 Stinger Fuel Control Add On Wires Install Video

[Terry@BMS]

Video of the upcoming JB4 fuel wire upgrade install.

 

[DaJackson]

Nice! Appreciate having install videos before the parts are even available.

 

[Kamauxx]

@Terry@BMS I'm about to buy the wire kit.

Questions first. Are the posi-taps included? Will the wires be okay with the insulation pulled back?

 

[Terry@BMS]

Yes, and yes.

 

[chivasGT2]

what plugs do you recommend? also how many catch cans needed for the 2018 stinger gt2? last for now open or closed k&n air intake? i deleted the mufflers am i missing something?

 

[Sabz]

what plugs do you recommend? also how many catch cans needed for the 2018 stinger gt2? last for now open or closed k&n air intake? i deleted the mufflers am i missing something?

Did you put straight pipe in place of muffler? If not how is the sound

 

[chivasGT2]

Did you put straight pipe in place of muffler? If not how is the sound

No straight pipes. it’s a very deep growing sound

 

[ChiTownStinger]

@Terry@BMS Have you seen any changes in MPG with the fuel control?

 

[Terry@BMS]

@Terry@BMS Have you seen any changes in MPG with the fuel control?

In theory economy at full throttle will be improved. But, we don't make any adjustments at part throttle.

 

[Kamauxx]

@Terry@BMS I got an email about a different wire being sent out but didn't receive a follow up. Are you sending new wires to those that received the wrong set or is there another step I need to take?

 

[Terry@BMS]

If you got an email then the longer wire without the resistor is on the way! If it doesn't turn up in a few days just email us back.

 

[Kamauxx]

Cool. Thanks!

 

[Kamauxx]

Okay so I just installed the wires. I uploaded V3 Firmware last week and it already had the values for fuel bias.

Is there any additional steps I need to take? Do I have to hit an "activate" button or something? Or should it be good from here?

 

[chivasGT2]

Okay so I just installed the wires. I uploaded V3 Firmware last week and it already had the values for fuel bias.

Is there any additional steps I need to take? Do I have to hit an "activate" button or something? Or should it be good from here?

what are you doing Kamauxx?

 

[Kamauxx]

what are you doing Kamauxx?

Trying to figure out the fuel control mod.

And I think I did. Found a pic of the settings on another forum. The JB4 didn't have then already as I'd previously thought.

Here are the settings we need to put in the fuel bias screen if anyone needs it.

 

[DaBears4Lyfe]

I entered the data in with the power on and engine off set the info and clicked save. I think it asked another question afterwards like activate, cant recall.

Anyone have any info on the proper way to mix fuel to run map 3 and 5?

 

[Kamauxx]

I put the info in, hit save, disconnected it, and then reconnected it to see if the values remained. They were still there so I guess that's the way to go.

 

[Killian]

Where does the blue wire go that's comming off the bluetooth connect module?

 

[Stingergt0618]

Where does the blue wire go that's comming off the bluetooth connect module?

blue wire to the red wire on the JB4 to power it. use the tap provided and make sure pointed side is on correctly. also make sure you do it outside the JB4 box

 

[Terry@BMS]

Yes when adding fuel wires at that point enable them in the software.