Bear
Active Member
So just got finished installing the K&N intake and it was a fairly straight forward install. I think the only thing I needed the manual for was which size clamps went where. I’m sure I would have been fine with my guesstimates, but didn’t want to jack it up.
Like others have complained, this is one stock hose and clamp that is just a tad too big for one of the connections on the driver side intake pipe. I’ll just get a better clamp and I’m sure it’ll be fine.
You can definitely hear it sucking in air around 2k-3k RPM. This goes perfectly with my Borla exhaust since it’s best sound is around this range.
First video is after the install and driving to 25mph from a stop sign in eco mode.
Dropbox - Video May 08, 8 45 31 PM.mov
This video is in sport mode and getting on it a little bit.
Dropbox - Video May 08, 9 00 56 PM.mov
Like others have complained, this is one stock hose and clamp that is just a tad too big for one of the connections on the driver side intake pipe. I’ll just get a better clamp and I’m sure it’ll be fine.
You can definitely hear it sucking in air around 2k-3k RPM. This goes perfectly with my Borla exhaust since it’s best sound is around this range.
First video is after the install and driving to 25mph from a stop sign in eco mode.
Dropbox - Video May 08, 8 45 31 PM.mov
This video is in sport mode and getting on it a little bit.
Dropbox - Video May 08, 9 00 56 PM.mov