WMI pump problems

[Satoshi’s stinger]

If this is in a thread somewhere please point me in that direction. So I installed the wmi kit last night and i have no power to my pump. I opened the fsb and the light is blinking green but when I try to purge from my phone nothing.
I’m going to open up the jb4 today make sure I’m in the right slots and fully in and try to backtrack myself just wondering if anyone else had the same issue

 

[Erocked]

I had a problem with mine when I first installed it. My issue ended up being the power prong, I inserted both ends into the fuse slot instead of cutting off 1 side and plugging the single prong into the hot side of the slot.

 

[Satoshi’s stinger]

I had a problem with mine when I first installed it. My issue ended up being the power prong, I inserted both ends into the fuse slot instead of cutting off 1 side and plugging the single prong into the hot side of the slot.

I’ll look into this tomorrow. On the pump itself?

 

[Erocked]

I’ll look into this tomorrow. On the pump itself?

No, the power wire that runs from the pump to the fuse box under the hood. Check it at the fuse box.

 

[G70LEbyAdoom]

No, the power wire that runs from the pump to the fuse box under the hood. Check it at the fuse box.

You don't have to cut the prong. mine works just fine in the fuse slot with both attached.

 

[Satoshi’s stinger]

Got it fixed thank you guys for the help!

 

[Anassalameh]

I have the same issue exactly, let me know how did you fix it please

 

[Satoshi’s stinger]

Wire shipped this morning should have them early next week I’ll keep you posted!

 

[Satoshi’s stinger]

Oh crap I fixed this problem! Lol so the wires going into the jb4 I had in the wrong spots they were not in 3 and 16 they were on the opposite side!!

 

[Terry@BMS]

We're going to work on upgrading these to include a fuse jumper rather than the fork in the future. Should make installation a little easier.