So I was on my way to work and decided to flash this firmware file JB4_P21_KIA_V22_T4.hex while I was driving. Stupid mistake as I lost all my power and was forced to pull over and figure it out. I tried restarting the car and connecting to the JB4, but when I did it said that I had no firmware and that the car would not work properly (something like that). I was in a hurry so I just ended up taking the JB4 out and run it stock to work. I'm sure this is an easy fix, does anyone have suggestions? It would be much appreciated
-
Click HERE to ask your JB4 Question! -
Whoops
- Thread starter jlwhitee
- Start date
You tried flashing while driving? As they say down south, bless your heart...lol
I've actually done the same accidentally, but while parked; it's an easy fix. Just reconnect everything when you're ready, press the start button twice (foot OFF the brake) to connect to the app via Bluetooth with the engine off and then you'll be ready to flash the firmware version of your choice.
I've actually done the same accidentally, but while parked; it's an easy fix. Just reconnect everything when you're ready, press the start button twice (foot OFF the brake) to connect to the app via Bluetooth with the engine off and then you'll be ready to flash the firmware version of your choice.
Thank you sir
rpoffen
1000 Posts Club!
Nav update is something you can do while driving, jb4, not.
From interior to exterior to high performance - everything you need for your Stinger awaits you...
