Trunk fit - right side vs left

[Nedstand]

I recently noticed the drivers side of the trunk doesn't fit as flush as the pax side. Anyone else have this also?

Sorry about the typo in the title, should be "right side vs left"

 

[DarthVaderIX]

No, that is off by a mile. Take it in

 

[Kamauxx]

The adhesive that holds it down has probably come apart.

 

[Bigjohnb20]

Yes mine looks very similar. I posted these (bad) photos in a different thread not too long ago. The consensus was that it should be a better fit.

 

[Callum]

There are a few parts that hold the rear decklid down. One, being a bolt right in that area. I'm betting it's not fully seated.

Garbage photo, but it's the very end bolt. Mine was finger tight

 

[Bigjohnb20]

Thanks I'll have a look soon

 

[Callum]

Thanks I'll have a look soon

If you remove the bumper things on the edges of the trunk you will see that bolt. Just make sure it's tight.

 

[Nedstand]

If you remove the bumper things on the edges of the trunk you will see that bolt. Just make sure it's tight.

I just checked and the nut is tight. I'll have them look at it when I bring the stinger in to address the recall.

 

[DiabloStinger]

The foam tape holds it against the frame of the hatch. I bet yours is separated.