3.3TT P0456 Error code

Edwardb1

Member
Joined
Dec 28, 2017
Messages
51
Reaction score
40
Points
18
Location
Minnesota
So I bought a scan tool to diagnose my CEL, and it was P0456- Evaporative Emission System Leak Detected(very small leak)
I checked my gas cap and filler neck, and noticed some rust on the lower portion of the the filler neck. Could this cause the leak? I cleaned the gas cap and filler neck with WD-40 and put more gas in, but the code remains. I can’t get in to the dealer in a timely manner due to the “KiaBoyz” breaking so many Kias. Should I try to remove the rust, or do I start buying parts? Thanks in advance!
 

Attachments

  • IMG_0880.webp
    IMG_0880.webp
    52.2 KB · Views: 6
  • IMG_0881.webp
    IMG_0881.webp
    64.7 KB · Views: 3
The code won't go away by itself. You didn't state that you cleared it. Clear the code with your scanner or the JB can also read and delete CEL's. Let the gas run down below 3/4 tank. The ECU won't run a proper test on a full tank, (Ref. I/M test)
 
Thanks! I cleared the code, and It’s been two days without the CEL. I never cleaned the gas cap or filler neck since I bought the car new, so maybe that was the magic bullet.
 
Went for 3 years of dealers trying to fix this code finally I installed an afe takedavv cv open cold air intake, changed the MAF valve and disconnected the battery for a hard reset. After a few days driving the light went off and never came back. Not sure what effect the CAi had but it did change the code from a mass leak to a minor leak and after changing the MAF no more codes
 
Back
Top