Good KDM Warehouse Devil's Claws

[TenTwo]

KDM Warehouse

Purchased a set of LED Devil's Claws. They got them shipped almost instantly, got here super fast! Thank you for getting them shipped so quickly.

In the packaging I received two tightly bubble wrapped Claws and two wires to help extend to the headlight housing. Contents were perfect on arrival.

If I could offer some advise: I recommend you also provide instructions in the packaging. I have no idea what to do with these wires. I found some instructions on the internet, but the pictures are grainy and instructions tell you what to do; I would love to know HOW to do. An instructional video might help a lot.

I'm going back to the store today to grab some T Tabs which may help me get them connected today.

I've been looking all over this forum and FB Stinger pages trying to find someone to help. I texted the number pretty late last evening and received an auto out of office response.

I would love to see anyone's pictures of this installed (for the wiring). Right now, based on hours of YouTube surfing, I've decided I need to buy a few T Taps and connect them near the headlight wiring connects.

I do have the Devil's Claws installed on the vehicle, and they look great. There is some protective plastic you'll want to pull off each side of each claw, once you unpackage them. I say this to anyone who uses search function, because it wasn't immediately obvious to me.

I'm admittedly not the smartest person when it comes to wiring anything, so this feedback may not be applicable to your more experienced or educated customers.

Again, overall, my experience is really good. Got what I ordered very fast, and they look great on the vehicle. Application was fairly easy.

 

[Aarvix]

I just grounded mine to the body and tapped into the power wires using T-taps. Easier this way since not all black wires are grounds (found that out the hard way).

 

[TenTwo]

I just grounded mine to the body and tapped into the power wires using T-taps. Easier this way since not all black wires are grounds (found that out the hard way).

So I need to split the red and black wire, and attach the black wire to the body and the red to the yellow going into the headlamp?

 

[TenTwo]

I’m about to snap. Nothing better in life than having the whole internet tell you how easy something is and no matter what you try you can’t get something to work.

How can I test the lights without hooking them up to my car?

 

[Puckhead]

I had tested mine before attaching them to the car with a 9 volt battery.

 

[TenTwo]

Thanks for the tip. The lights do indeed work. I’m trying some different connectors today. Really don’t want to pay someone to solder but I am losing confidence in my abilities quickly.

 

[TenTwo]

Takes most people an hour or two. Took me about 10. But, if I can do it anyone can. If you order these, just order some t taps off Amazon too.