Currently I’m having issues connecting to the JB4 since install my CPI/Fuel It Kit. I was told since my Fuel It kit is on constant power and not on switched power it will cause connection issues for the JB4. Only solution currently to get both to run at the same time is to disconnect the battery. I went ahead and linked below what I’m working with currently. Thanks!
-
Click HERE to ask your JB4 Question! -
JB4/Fuel It Connection Issues
- Thread starter Mtowns5
- Start date
Baluchitherium4
Active Member
I had the same issue as you did at first when I had it on constant power. I now run them both off the same switched power location and haven't had any issues since.
Any suggestions on which 10A is switched power?
cLaw
Active Member
- Joined
- Oct 9, 2022
- Messages
- 182
- Reaction score
- 58
- Points
- 28
Me and another user have went down this route and searched a bunch. Look up the CPI kit installation and they show which 10a they use.
Baluchitherium4
Active Member
I used a volt meter to find the right one. You should be able to look at the cpi or meth installation instructions from either bms or lap3 and find the correct location for the fuse tap.
From interior to exterior to high performance - everything you need for your Stinger awaits you...
