Check Engine after Intake, CC, and SparkPlug Install

[Jbran23]

So i purchased the BMS package with the JB4, Air intakes, oil CC, and DENSO plugs. Im not a car guy so I had a mechanic come out and do the install of everything EXCEPT the JB4.

After everything was in we went for a ride around the block. Car started up fine. Everything sounds good. Idle sounds good. Did a couple accelerations and the intakes sounded good. No issues.

Got home and shut the car off. Went back out about 10 minutes later to go grab something to eat and the check engine light came on immediately. And ideas what that could be. I did the diagnostic in the UVO and it just says possible engine condition.

 

[Terry@BMS]

Read the codes.

 

[Jbran23]

Read the codes.

Hi Terry. I realized that if I hooked up the JB4 I might be able to see what the code is but when I hooked it up and hit read codes it comes back with "Invalid read. Please try again".

 

[Jbran23]

I have edited the original post because I dont think it was clear that I had not hooked up the JB4 yet when I got the check engine light.

 

[nhcowboy28]

Check with miss Cleo...

Or... read the GD codes.

 

[General_Vodka]

Probably a loose sensor. The uvo said possible engine condition when half my front was crashed in and a turbo was busted. Even a $5 code reader from CHINAA will tell you more

 

[Terry@BMS]

Hi Terry. I realized that if I hooked up the JB4 I might be able to see what the code is but when I hooked it up and hit read codes it comes back with "Invalid read. Please try again".

Data cable? Update windows software we fixed a bug with it recently. If it's blue tooth make sure it had the latest firmware.