NGI Piggyback Shield Fuse Box Cover/ ECU Cover

[Ngrieco]

Hey guys this is the ORIGINAL NGI piggyback shield and ECU cover. This design is simple yet effective. Both passenger and drivers side are in stock and ready to ship. Hit up Nick at Khartunerz for this weekend’s special! Proudly made in the USA


NGI Piggyback Shield for JB4, RaceChip or ProTuner - KIA STINGER DOT COM

 

[Hockster]

Twice as much as the other set, and honestly using 3M tape seems cheap.

 

[Ngrieco]

Twice as much as the other set, and honestly using 3M tape seems cheap.

This is for a set (2 sides). The passenger side uses velcro for easy on and off access. And it’s made here in the USA.

 

[xot1]

I dont like that left and right side are uneven.
But I may be OCD.

 

[Ngrieco]

I dont like that left and right side are uneven.
But I may be OCD.

I dont like that left and right side are uneven.
But I may be OCD.

I think they look pretty damn good

 

[DSM]

I got mine and it looks great

 

[Kato_the_kia_stinger]

The left and right are the same with the new set up of the NGI. They take no time at all to install. They use the factory push clips and are very clean looking.

 

[Ngrieco]

Newest version is in stock and ready to ship!

 

[Hockster]

Gotta remove the shield to fill the washer fluid?

 

[ChaneRZ]

Looks like it. I have the BMS shield and it is open for the windshield washer fluid.

 

[Ngrieco]

Gotta remove the shield to fill the washer fluid?

Yep! Takes about 10 seconds to remove and looks much better covered up