I’m just wonder for you guys with the jun evc how much wiring and vacuum tubing needs to be run and where does it all run too. I don’t want to have to pop open panels in the car to fish wires and have to drill anything. If I decide to sell the car and take it out I don’t want any sign it was installed. Any info would be great.
Jun evc install question
- Thread starter Adamdan
- Start date
StingerNYC
Active Member
I uploaded the .PDF instructions here. I do not have this exhaust but used it to help me install a maintec evc system.
JunB.L EVC Exhaust – Google Drive
With the Jun system you will need to run a wire inside the cabin and find somewhere to put the switch. You will have to get creative if you want the switch in a spot that wont be noticeable when removed. With maintec system I have it uses a wireless remote and all the wiring is under the hood/car.
JunB.L EVC Exhaust – Google Drive
With the Jun system you will need to run a wire inside the cabin and find somewhere to put the switch. You will have to get creative if you want the switch in a spot that wont be noticeable when removed. With maintec system I have it uses a wireless remote and all the wiring is under the hood/car.
Thanks. How loud is the exhaust with valves open? I’m wondering if I should just go with gt instead if it’s not to loud around town and does not get bad drone.
Joshua
Member
I'm not very mechanically inclined, so I honestly don't know how exactly install the exhaust myself, but the shop I took it to had to drill one hole that I know of in the back right of the engine bay. Couldn't tell you what exactly they drilled into, but I uploaded a picture. Hopefully that helps. Couldn't be happier with the exhaust though!
