Will this set up fit?

[Kasketvall]

I’m planning on going with a Aodhan ah02 19x9.5 not sure on the offset I’d like it to be flush or close to it. Is this posible? Will I need spacers? I’m fully stock if that helps. Any help would be greatly appreciated.

 

[Snicklefritz]

You are going to have a challenge getting the front to take a 9.5. Offset will have to be pretty small, which then reaches for the fenders. In the rear, no problem. Spacers depends on the wheel, the spokes clearance, which varies with the same offset number between makes of wheel. Spacers are a last resort in my opinion.

 

[DKnMP]

I’m planning on going with a Aodhan ah02 19x9.5 not sure on the offset I’d like it to be flush or close to it. Is this posible? Will I need spacers? I’m fully stock if that helps. Any help would be greatly appreciated.

19*9.5 +29 works. Nearly bought a set of RAYS off a G70 owner and it was a great fit.

 

[Thomby]

You are going to have a challenge getting the front to take a 9.5

19*9.5 +29 works

I have 19x9.5 +30 in my list of wheels that fit (from @mikegt2 I believe).
- We're adding 1.5" width, or 0.75" (19mm) inside and out, then shifting 4-5mm outward
- That means the inside edge is ~14mm or 0.55" further inside, ie the stock setup has to have that much suspension clearance
- The outside edge is ~24mm or just under 1" further outside. A 20mm (0.8") spacer pushes stock wheels pretty flush, so this is probably at the limit of how much you'd want to poke.

At the rear, you're adding 1" width, or 0.5" (12.7mm) inside & out, but from the stock +46.5 a +30 will push you 16.5mm or 0.65" further out. Net result is inside edge about 4mm further out, outside edge a whopping 29.2mm (1.15") further out. If the goal is a square setup, it would probably be better to go with a +40 or +45 offset, and a 10-15mm spacer up front.