Stage 2 Snow WMI

[ryan1stinger]

For anyone who has the Stage 2 Snow WMI. The MAP sensor needs to read positive boost pressure in order to configure the starting and full boost setting for WMI, therefore did you drill a 1/8 NPT hole in your cold side charge pipe for this sensor or is there anyway around this? I have the UP cold side charge pipe. Taking my car to the mechanic tomorrow to install the WMI kit and if they now have to uninstall the charge pipe, drill a hole and attach it, that will add to the time which will cost me more money.

Given the boost pressure sensor is already connected to the charge pipe it would be great if we could connect this to the controller and VC-30 from Snow.

 

[ryan1stinger]

Ahh. In chatting with Tonkabob I believe the issue is that Snow sent me a VC-40 controller instead of a VC-50. Has anyone installed this with the VC-50 controller and did you simply push the MAP sensor onto a bung as there are no threads?

 

[ryan1stinger]

Sorry, I have the VC-30

 

[Stock_stinger]

that sensor gets the boost line from the blow off valve tied into it.

 

[ryan1stinger]

that sensor gets the boost line from the blow off valve tied into it.

So the MAP sensor, in my pic, should be attached to the blow off valve. I will have to see how that can be attached to the line going to the blow off valve. When I called Snow tech support they mentioned attaching it to the charge pipe. Probably either way will work.

 

[Stock_stinger]

It's just a pressure sensor. They said charge pipe so your getting boost pressure. T it into the blow off valve lime on the lower side if the solenoid. Not the line directly hooked to the blow off's but the one that goes lower into the charge pipe