Roof wrap, what did you do with the trim?

[AJG]

I have the ceramic silver GT2 and the rubber molding on the sides of the trim cant be wrapped. What have others done about this? Should I order the trim for a black stinger and swap it out?

 

[Kato_the_kia_stinger]

I plastidipped them.

 

[Ulikefishsticks]

I had mine wrapped, Not sure how they did it but it turned out looking fine. I'll see how it looks after a few months.

 

[Kato_the_kia_stinger]

I had mine wrapped, Not sure how they did it but it turned out looking fine. I'll see how it looks after a few months.

The rubber wouldn’t have been able to be wrapped. What did they do for that?

 

[Ulikefishsticks]

I have no clue, I'll go down later today and take a look at it.

 

[Dmango]

Any one know how to remove the trim. I want to put some more layer of clear coat on it to prevent from cracking which is very common from other people in the forum.

 

[westcoastGT]

I just left it , it looks fine in my opnion

 

[MerlintheMad]

Any one know how to remove the trim. I want to put some more layer of clear coat on it to prevent from cracking which is very common from other people in the forum.

I haven't done it. But somebody(s) said it just unclips at the back end and lifts out. I know it isn't screwed in or anything complicated. (this is when photographic memory would come in handy, so I could link to the post, hah)

 

[TwiceStung]

Had Halo EFX put on mine as well as the shark fin to match the black roof wrap. The entire roof was supposed to be Halo EFX but they guy doing it f'd it up. The fin and drip rails are fine though. He then wrapped around the shark fin. I did the rest of the top myself. Wonder what happens if those little rubber strips on either side of the rails are not there?