JB4 - issue with no boost

[Origins]

Installed JB4 w/fuel wires and was working fine, however found cables were running too hot around some areas of the engine. Disconnected and rerouted wires, reconnected and turned on engine - CEL turned on P0200 code. Cleared with JB4 app and returned to Map 1 before unplugging JB4 to return car back to stock. Ran car on stock fine, waited 15 mins and reinstalled JB4 and fuel wires, however car turned on and app showed boost at 25.4 and was blue colored instead of green. Took car out for a quick test and noticed no boost at all with the JB4. Returned car back to stock and boost was back. Please help, what could be the issue?

 

[Terry@BMS]

Sounds like a MAP sensor fault triggered, must be a loose wire or connection. You can also check the JB4 control board to ensure it's connector is tight and isn't damaged.

 

[Origins]

Sounds like a MAP sensor fault triggered, must be a loose wire or connection. You can also check the JB4 control board to ensure it's connector is tight and isn't damaged.

Thanks Terry, will check and update

 

[Origins]

Sounds like a MAP sensor fault triggered, must be a loose wire or connection. You can also check the JB4 control board to ensure it's connector is tight and isn't damaged.

Hi Terry, all good now. I've attached a log, let me know if any issues that you can see. Thanks

 

[ChiTownStinger]

Hi Terry, all good now. I've attached a log, let me know if any issues that you can see. Thanks

What was the fix for your issue?

 

[Origins]

What was the fix for your issue?

Sorry for the late reply.

I just unplugged, clear codes and started over from scratch. Maybe a connection was loose but no issues since then.