jluppens
Member
- Joined
- Jul 6, 2020
- Messages
- 23
- Reaction score
- 15
- Points
- 3
Well, finally got some time to install my BMS intakes. Install not too bad being somewhat novice. I had a lot of issues with attaching the pipes to the heat shields. The threads on the pipe did not seem to be bored out well and had paint in them. I had a hell of a time screwing them in. Passenger side required me adding a locking nut to the bolt to get it to tighten down as the threads stripped completely. Definitely a difference in the sound before and after as seen in the videos. Haven't had a chance to take it out to test the butt dyno due to poor weather, but hopefully I will get out soon.
