cold side charge pipe

  1. JERisBRISK

    Injen Short Ram Intakes + aFe BladeRunner Hot & Cold Charge Pipes

    That was a real beast of an install, but it’s done. Sort of. Post-op: Pre-op: Stuff of note: These pipes would be fine if aFe hadn’t moved the air sensor from the front to the side of the charge pipe… as it is now, the Short Ram rests (therefore can rub) against the connector housing...
  2. ryan1stinger

    Possibly screws missing from engine?

    I removed the OEM cold side charge pipe in preparation for installing the ultimate performance cold side charge pipe and noticed there a few slots where screws could be installed but are not. I’m thinking this is be design, but want to make sure I’m not missing screws. May be tough to see the...
Back
Top